To prolong the service life of SAIQ bearings, just master these points（一）
SAIQ bearings are important joints of mechanical equipment. In order to prolong the service life of the bearings, daily maintenance is inevitable. In order to make SAIQ bearings more suitable and longer life, SAIQ will provide you with an understanding of all aspects of bearings. Share the daily maintenance and maintenance knowledge about the bearing, as long as you master these points, there is no problem with the life extension of the bearing.
First of all, in order to make SAIQ bearings give full play to and maintain their due performance for a long time, it is necessary to do regular maintenance (regular inspection).
Second, in the regular inspection of SAIQ bearings, early detection must be done if there is a fault, to prevent accidents before they happen, which is very important to improve productivity and economy.
Third, SAIQ bearings are coated with an appropriate amount of anti-rust oil and packed with anti-rust paper when they leave the factory. As long as the packaging is not damaged, the quality of SAIQ bearings will be guaranteed.
Fourth, if SAIQ bearings are stored for a long time, they should be stored on a shelf 30cm above the ground under the conditions of humidity lower than 65% and temperature of about 20℃. In addition, the storage place should avoid direct sunlight or contact with cold walls.
Fifth, after cleaning the bearing during SAIQ bearing maintenance, the steps that need to be carried out are as follows:
a. First of all, when the SAIQ bearing is disassembled and inspected, the appearance should be recorded by photography and other methods. In addition, confirm the amount of remaining lubricant and sample the lubricant before cleaning the bearing.
b. The cleaning of SAIQ bearings is divided into rough washing and fine washing, and a metal grid can be placed at the bottom of the container used.
c. When rough washing, use a brush in oil to remove grease or adhesions. If the bearing is rotated in oil at this time, be careful that the rolling surface may be damaged by foreign matter.
d. When fine washing, slowly rotate the bearing in oil, and must be carried out carefully. Commonly used cleaning agents are neutral non-water-containing diesel or kerosene, and sometimes warm lye etc. are used as needed. No matter which cleaning agent is used, it must be filtered frequently to keep it clean.
e. After cleaning, immediately apply anti-rust oil or anti-rust grease on the bearing.
Sixth, when disassembling and installing SAIQ bearings, professional tools and corresponding safety steps must be used to properly install and remove the bearings.